R&S RTO6 - Page 1819

Remote control commands
R&S
®
RTO6
1819User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:CAN:FDATa:STANdard <SearchName>,<Standard>
SEARch:TRIGger:CAN:
FDA
Ta:STANdard? <SearchName>
Selects the CAN standard: CAN, CAN FD, or Any.
Use "Any" to search on either CAN or CAN-FD frame. In this case, the search configu-
ration provides all possible settings, for CAN as well as for CAN FD.
The setting is available in CAN FD option.
Parameters:
<Standard> ANY | CAN | CANFd
*RST: CAN
Parameters for setting and query:
<SearchName> String with the search name
SEARch:TRIGger:CAN:FTYPe <SearchName>,<FrameType>
SEARch:TRIGger:CAN:
FTYPe? <SearchName>
Selects the CAN frame type to be searched for.
For data and remote frames, the identifier format has to be set with SEARch:
TRIGger:CAN:ITYPe on page 1819.
Parameters:
<FrameType> ANY | DATA | REMote | ERRor | OVERload
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CAN:ITYPe <SearchName>,<IdentifierType>
SEARch:TRIGger:CAN:
ITYPe? <SearchName>
Selects the format of data and remote frames: 11 bit for CAN base frames, or 29 bits
for CAN extended frames.
Parameters:
<IdentifierType> ANY | B11 | B29
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CAN:ICONdition <SearchName>,<IdOperator>
SEARch:TRIGger:CAN:ICONdition? <SearchName>
Sets the operator to set a specific identifier or an identifier range.
Parameters:
<IdOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
Protocols