R&S RTO6 - Page 1849

Remote control commands
R&S
®
RTO6
1849User Manual 1801.6687.02 ─ 05
SPERror: stop error
PRERror: parity error
UV
AL: unexpected value
NOEXists: byte does not exist
INSuf
ficient: the frame is not completely contained in the acqui-
sition. The decoded part of the frame is valid.
*RST: OK
Usage: Query only
BUS<m>:LIN:FRAMe<n>:IDValue?
Returns the identifier value of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<IdentifierValue> To set the value format, use FORMat:
BPATtern
.
The values below – range, increment and reset – are decimal
values.
Range: 0 to 63
*RST: 0
Usage: Query only
BUS<m>:LIN:FRAMe<n>:IDPValue?
Returns the value of the identifier parity bits of the selected frame.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the frame.
Return values:
<IdtfParityValue> To set the value format, use FORMat:BPATtern
.
The values below – range, increment and reset – are decimal
values.
Range: 0 to 3
*RST: 0
Usage: Query only
Protocols