R&S RTO6 - Page 1853

Remote control commands
R&S
®
RTO6
1853User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:LIN:DLENgth.....................................................................................
1858
SEARch:TRIGger:LIN:
IPERror...................................................................................... 1858
SEARch:TRIGger:LIN:SYERror..................................................................................... 1858
SEARch:TRIGger:LIN:CHKSerror..................................................................................1858
SEARch:TRIGger:LIN:ERRPattern.................................................................................1859
SEARch:TRIGger:LIN:CRCDatalen................................................................................1859
SEARch:TRIGger:LIN:STANdard...................................................................................1859
SEARch:TRIGger:LIN:SSOFrame <SearchName>,<FrameStart>
SEARch:TRIGger:LIN:SSOFrame? <SearchName>
Enables the search for the stop bit of the sync field, which marks the frame start.
Parameters:
<FrameStart> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:SFIDentifier <SearchName>,<Identifier>
SEARch:TRIGger:LIN:SFIDentifier? <SearchName>
Enables the search for one specific identifier or an identifier range.
Parameters:
<Identifier> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:IDENtifieror <SearchName>,<IdentifierOr>
SEARch:TRIGger:LIN:IDENtifieror? <SearchName>
Enables the search for one to four address conditions.
Parameters:
<IdentifierOr> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:LIN:SIDData <SearchName>,<IdentifierData>
SEARch:TRIGger:LIN:SIDData? <SearchName>
Enables the search for a combination of identifier and data conditions.
Protocols