R&S RTO6 - Page 1975

Remote control commands
R&S
®
RTO6
1975User Manual 1801.6687.02 ─ 05
●
CMD: for command words
●
CDST
: for status words
Parameters:
<R
TAOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with
SEARch:TRIGger:MILStd:CDST:RMIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:MILStd:CDST:RMIN and
SEARch:TRIGger:MILStd:CDST:RMAX on page 1975.
*RST: EQUal
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:MILStd:DATA:RMIN <SearchName>,<RT
APatternMin>
SEARch:TRIGger:MILStd:DATA:RMIN? <SearchName>
SEARch:TRIGger:MILStd:CMD:RMIN <SearchName>,<RTAPatternMin>
SEARch:TRIGger:MILStd:CMD:RMIN? <SearchName>
SEARch:TRIGger:MILStd:CDST:RMIN <SearchName>,<RTAPatternMin>
SEARch:TRIGger:MILStd:CDST:RMIN? <SearchName>
Specify a remote terminal address or set the the start value of a remote terminal
address range:
●
DATA: for data words
●
CMD: for command words
●
CDST: for status words
Parameters:
<RTAPatternMin> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page
1286. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MILStd:DATA:RMAX <SearchName>,<RTAPatternMax>
SEARch:TRIGger:MILStd:DATA:RMAX? <SearchName>
SEARch:TRIGger:MILStd:CMD:RMAX <SearchName>,<RTAPatternMax>
SEARch:TRIGger:MILStd:CMD:RMAX? <SearchName>
SEARch:TRIGger:MILStd:CDST:RMAX <SearchName>,<RTAPatternMax>
SEARch:TRIGger:MILStd:CDST:RMAX? <SearchName>
Set the end value of a data range if SEARch:TRIGger:MILStd:CDST:RCONdition
is set to INRange or OORange:
Protocols