Remote control commands
R&S
®
RTO6
1988User Manual 1801.6687.02 ─ 05
TRIGger<m>:ARINc:LABel:CONDition <LabelOperator>
Sets the condition for the label. Y
ou can define an exact label or a label range.
Parameters:
<LabelOperator>
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with
TRIGger<m>:ARINc:LABel:MIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range withTRIGger<m>:ARINc:LABel:MIN and
TRIGger<m>:ARINc:LABel:MAX.
*RST: EQUal
TRIGger<m>:ARINc:LABel:MIN <LabelMin>
Defines the minimum bit pattern for the label.
Parameters:
<LabelMin> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:ARINc:LABel:MAX <LabelMax>
Sets the end value of a label pattern if TRIGger<m>:ARINc:
LABel:CONDition is
set to INRange or OORange.
Parameters:
<LabelMax> Numeric or string pattern, see TRIGger<m>:ARINc:LABel:
MIN
TRIGger<m>:ARINc:MINGap:SELect <MinGapSelect>
Enables triggering when the minimum gap is out of range. You can set the minimum
gap with:
TRIGger<m>:ARINc:MINGap:BITS.
Parameters:
<MinGapSelect> ON | OFF
*RST: ON
TRIGger<m>:ARINc:MINGap:BITS <MinGapBits>
Sets the value for the minimum gap to be triggered on.
Protocols
To Next Page
Loading...
