R&S RTO6 - Page 2072

Remote control commands
R&S
®
RTO6
2072User Manual 1801.6687.02 ─ 05
Usage: Query only
BUS<m>:RFFE:SEQuence<n>:SADD?
Returns the slave address of the selected command sequence.
Suffix:
<m>
.
1..4
<n> *
Return values:
<FrameSID> Range: 0 to 15
Increment: 1
*RST: 0
Usage: Query only
BUS<m>:RFFE:SEQuence<n>:ADDRess?
Returns the register address of the selected command sequence.
Suffix:
<m>
.
1..4
<n> *
Return values:
<FrameAddress> Range: Depends on the sequence type, address can have
0, 5, 8, or 16 bits
Increment: 1
*RST: 0
Usage: Query only
BUS<m>:RFFE:SEQuence<n>:BCOunt?
Returns the bit/ byte count of the selected command sequence.
Suffix:
<m>
.
1..4
<n> *
Return values:
<ByteCount> Decimal value
Range: 15
Increment: 1
*RST: 0
Usage: Query only
Protocols