R&S RTO6 - Page 2118

Remote control commands
R&S
®
RTO6
2118User Manual 1801.6687.02 ─ 05
BUS<m>:TBTO:RDAP <SourceRevDAplus>
Selects the DA+ source of the provided reversed single ended signal, if BUS<m>:
TBTO:RTYP is set to SINGle.
Suffix:
<m>
.
1..4
Parameters:
<SourceRevDAplus> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 |
R1 | R2 | R3 |
R4
BUS<m>:TBTO:RDIF <SrcRevDiff>
Sets the source of the provided reversed dif
ferential signal, if BUS<m>:TBTO:RTYP is
set to DIFFerential.
Suffix:
<m>
.
1..4
Parameters:
<SrcRevDiff> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
BUS<m>:TBTO:RTYP <SignalRevT
ype>
Sets the type of reverse signal measurement.
Suffix:
<m>
.
1..4
Parameters:
<SignalRevT
ype> DISabled | DIFFerential | SINGle
*RST: DISabled
BUS<m>:TBTO:MODE <Mode>
Selects the direction of the full-duplex signal you want to look at.
Suffix:
<m>
.
1..4
Parameters:
<Mode> MASTer | SLAVe | AUTO
*RST: AUTO
BUS<m>:TBTO:POLarity <Polarity>
Selects the polarity of the data signal.
Suffix:
<m>
.
1..4
Protocols