R&S RTO6 - Page 2135

Remote control commands
R&S
®
RTO6
2135User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:TBTO:CRC:MIN <SearchName>,<CRCPatternMin>
SEARch:TRIGger:TBT
O:CRC:MIN?
<SearchName>
Specifies the frame check bit pattern, or sets the start value of a pattern range.
Parameters:
<CRCPatternMin> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (do not care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:TBTO:DADDress:CONDition <SearchName>,<DestAddrOptor>
SEARch:TRIGger:TBTO:DADDress:CONDition? <SearchName>
Sets the condition for the destination address. You can define an exact value or a value
range.
Parameters:
<DestAddrOptor> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:
TRIGger:TBTO:
DADDress:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:TBTO:DADDress:MIN and
SEARch:TRIGger:TBTO:DADDress:MAX.
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:TBTO:DADDress:MAX <SearchName>,<DestAddrPattMax>
SEARch:TRIGger:TBT
O:DADDress:
MAX? <SearchName>
Sets the end value of the destination address range if SEARch:TRIGger:TBTO:
DADDress:CONDition is set to INRange or OORange.
Parameters:
<DestAddrPattMax> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (do not care).
Parameters for setting and query:
<SearchName>
Protocols