R&S RTO6 - Page 2149

Remote control commands
R&S
®
RTO6
2149User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
BUS<m>:USB:DIFFerential:SOURce <SrcDif
f>
Selects the source for the dif
ferential signal in the USB high speed protocol.
Suffix:
<m>
.
1..4
Parameters:
<SrcDiff> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 |
R4
*RST: C1W1
Usage: Asynchronous command
BUS<m>:USB:DATA:SOURce <SourceData>
Selects the source for the data signal in the USB HSIC protocol.
Suffix:
<m>
.
1..4
Parameters:
<SourceData> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 |
R1 | R2 | R3 |
R4
*RST: C1W1
Usage: Asynchronous command
BUS<m>:USB:STRobe:SOURce <SourceStrobe>
Selects the source for the strobe signal in the USB HSIC protocol.
Suffix:
<m>
.
1..4
Parameters:
<SourceStrobe> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 |
R4
*RST: C2W1
Usage: Asynchronous command
BUS<m>:USB:DPLus:THReshold <ThresholdDplus>
Defines the threshold level for the D+ data signal (in USB low speed and USB full
speed protocol, only).
Suffix:
<m>
.
1..4
Protocols