R&S RTO6 - Page 2172

Remote control commands
R&S
®
RTO6
2172User Manual 1801.6687.02 ─ 05
Parameters:
<DataPosOperator> ANY | OFF | EQUal
ANY = OFF
The position of payload data is not relevant for the search condi-
tion.
*RST: ANY
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:DPOSition <SearchName>,<DataPosition>
SEARch:TRIGger:USB:DPOSition? <SearchName>
Specifies the position within a payload data packet, in which a special data pattern is to
be searched.
Parameters:
<DataPosition> Range: 0 to 1024
Increment: 1
*RST: 0
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:ECONdition <SearchName>,<EndpointOptor>
SEARch:TRIGger:USB:ECONdition? <SearchName>
Sets the operator to set a specific endpoint or an endpoint range. The endpoint values
are set with SEARch:TRIGger:
USB:EMIN and SEARch:TRIGger:USB:EMAX.
Parameters:
<EndpointOptor> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one endpoint
value to be set using SEARch:TRIGger:
USB:EMIN.
INRange | OORange
In range, out of range. These conditions require a range of end-
point values to be set using SEARch:TRIGger:USB:EMIN and
SEARch:TRIGger:USB:EMAX.
*RST: OFF
Parameters for setting and query:
<SearchName>
Protocols