R&S RTO6 - Page 2245

Remote control commands
R&S
®
RTO6
2245User Manual 1801.6687.02 ─ 05
BUS<m>:DPHY:DSPData <DispDatV
ect>
Enables the display of the data vector
, which means that the whole frame will be deco-
ded.
When the display vector is disabled only the packet header will be decoded and not the
actual data payload of the frame. This will speed up the decoding.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<DispDatVect> ON | OFF
*RST: OFF
BUS<m>:DPHY:THCoupling <ThresCpl>
Enables coupling, i.e. the same threshold and hysteresis value is used for all lanes.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ThresCpl> ON | OFF
*RST: ON
BUS<m>:DPHY:THPReset <ThresholdPreset>
Prests the threshold and hysteresis values of the high speed data lanes. A preset sets
the low power threshold to 1.20V and high speed threshold to 200 mV.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ThresholdPreset>
LPHS | MANual
*RST: LPHS
BUS<m>:DPHY:VARiant <ProtSel>
Selects the protocol running on the interface.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ProtSel> DSI | CSI2
*RST: CSI2
Protocols