R&S RTO6 - Page 2322

Remote control commands
R&S
®
RTO6
2322User Manual 1801.6687.02 ─ 05
Parameters:
<Enable> ON | OFF
*RST: OFF
Example:
TRIGger:MPHY:SSIC:FRAMe1:ENABle ON
Enables the checking condition for the TSEQ frame.
TRIGger:MPHY:SSIC:
FRENable "TS1" ON
Enables the checking condition for the TS1 frame.
TRIGger<m>:MPHY:SSIC:FIENable <Frame>, <Field>, <Enabler>
TRIGger<m>:MPHY:SSIC:FRAMe<n>:FLD<o>:ENABle
<CondEnabler>
Enables or disables the checking condition for the selected field of the selected frame.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
<n> *
Specifies the field number within the frame.
<o> *
Specifies the field number within the frame.
Parameters:
<CondEnabler>
ON | OFF
*RST: OFF
Example:
TRIGger:MPHY:SSIC:FRAMe1:FLD1:ENABle ON
Enables the checking condition for the Symbol field of the TSEQ
frame.
TRIGger:
MPHY:SSIC:
FRENable "TS1", "Loop" ON
Enables the checking condition for the Loop field of the TS1
frame.
TRIGger<m>:MPHY:SSIC:BIT <Frame>, <Field>, <Bit>
TRIGger<m>:MPHY:SSIC:FRAMe<n>:FLD<o>:BIT <BitState>
Sets the bit state of a field that only consists of one bit.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
<n> *
Specifies the frame number.
<o> *
Specifies the field number within the frame.
Parameters:
<BitState> ONE |
ZERO | DC
*RST: DC
Protocols