R&S RTO6 - Page 2353

Remote control commands
R&S
®
RTO6
2353User Manual 1801.6687.02 ─ 05
TRIGger<m>:PCIE:DLLP:MULT:CRET <CreditT
ype>
Sets the credit type to be triggered on for the multi-root data link layer trigger
.
Parameters:
<CreditType> ANY | DATA | HEADER
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:DVPT <DevicePortType>
Sets the device/port type to be triggered on for the data link layer trigger
.
Parameters:
<DevicePortType> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN | EIGHT | NINE |
TEN | ELEVEN | TWELVE |
THIRTEEN | FOURTEEN | FIFTEEN
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:HABS <VHAbsent>
Sets the state of the absent virtual hieararchies (VH) to be triggered on for the data link
layer trigger.
Parameters:
<VHAbsent>
ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:MIXT <MixedType>
Sets the mixed type presence state to be triggered on for the data link layer trigger
.
Parameters:
<MixedType> ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:PHAS <Phase>
Sets the phase state to be triggered on for the data link layer trigger.
Parameters:
<Phase> ANY | YES |
NO
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:RESA <ResetA>
Sets the on the value of the A bit to be triggered on for the data link layer trigger.
Protocols