R&S RTO6 - Page 2354

Remote control commands
R&S
®
RTO6
2354User Manual 1801.6687.02 ─ 05
Parameters:
<ResetA> ANY | ACK | REQUEST
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:TLPT <TLPType>
Sets the multi-root type to be triggered on for the data link layer trigger
.
Parameters:
<TLPType> ANY | P | NP | CPL
P
Posted credit.
NP
Non posted credit.
CL
Completion credit.
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:TYPE <T
ype>
Sets the multi-root type for the data link layer to be triggered on.
Parameters:
<T
ype> MRINIT | MRRESET | MRUPDATEFC | MRINITFC1 |
MRINITFC2
*RST: MRINIT
TRIGger<m>:PCIE:DLLP:MULT:VHFC <InitVHFC>
Sets the virtual hierarchies flow control presence state to be triggered on for the data
link layer trigger.
Parameters:
<InitVHFC> ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:DLLP:MULT:VHGR <ResetVHGroup>
Sets the virtual hierarchies group to be triggered on for the data link layer trigger.
Parameters:
<ResetVHGroup>
ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN | EIGHT | NINE |
TEN | ELEVEN | TWELVE |
THIRTEEN | FOURTEEN | FIFTEEN
*RST: ANY
Protocols