R&S RTO6 - Page 2355

Remote control commands
R&S
®
RTO6
2355User Manual 1801.6687.02 ─ 05
TRIGger<m>:PCIE:DLLP:MULT:VLNR <V
irtualLink>
Sets the virtual link (VL) number to be triggered on for the data link layer trigger
.
Parameters:
<VirtualLink> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN
*RST: ANY
TRIGger<m>:PCIE:DLLP:POWM <PowerMngtType>
Sets the power management type to be triggered on for the data link layer trigger
.
Parameters:
<PowerMngtType> ANY | ENTERL1 | ENTERL23 | ACTREQL1 | REQUESTACK
*RST: ANY
TRIGger<m>:PCIE:DLLP:SEQ <ACKNAKSequence>
Sets the sequence field, indicating what TLPs are affected by the ACK/NAK, to be trig-
gered on for the data link layer trigger
.
Parameters:
<ACKNAKSequence>
TRIGger<m>:PCIE:DLLP:TYPE <T
ype>
Sets the DLLP t type to be triggered on for the data link layer trigger
.
Parameters:
<Type> ANY | MRDLLP | ACK | NAK | INITFC1 | INITFC2 | UPDATEFC |
PM | VENDOR
*RST
: ANY
TRIGger<m>:PCIE:DLLP:VPAT <VendorBtPatt>
Sets the vendor pattern to be triggered on for the data link layer trigger.
Parameters:
<VendorBtPatt> 24-bit pattern, see Chapter 24.4.6, "Bit pattern parameter",
on page 1286. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:ERRC:CRC <CRC16>
Enables triggering on 16-bit cyclic redundancy check (CRC) errors.
Parameters:
<CRC16> ON | OFF
*RST: OFF
Protocols