R&S RTO6 - Page 2428

Remote control commands
R&S
®
RTO6
2428User Manual 1801.6687.02 ─ 05
Parameters:
<DataFormat> HEX | OCT | BIN | ASCII | ASCii | SIGN | USIG
*RST: HEX
BUS<m>:PARallel:DISPlay:SHDI <ShwDigSigns>
If enabled, the selected digital signals are shown in the diagram. Each channel is dis-
played as a logic signal.
See also: DIGital<m>:DISPlay
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<ShwDigSigns>
ON | OFF
*RST: OFF
BUS<m>:PARallel:DISPlay:SHBU <ShowBus>
Shows or hides the indicated parallel bus. If enabled, the resulting bus signal and bus
values are displayed in the diagram.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<ShowBus> ON | OFF
*RST: OFF
BUS<m>:PARallel:DISPlay:BTYP <BusRepres>
Selects the display type of the indicated parallel bus.
Suffix:
<m>
.
1..4
Selects the parallel bus.
Parameters:
<BusRepres> COMB | ANALog
COMB
Displays the decoded bus signal with bus values.
ANALog
Displays the bus value as amplitude, similar to an analog wave-
form.
*RST: COMB
Mixed signal option (MSO, R&S RT
O6-B1)