R&S RTO6 - Page 2511

Remote control commands
R&S
®
RTO6
2511User Manual 1801.6687.02 ─ 05
Set CUSTOM to adjust the bit rate and the bandwidth manually
.
Suffix:
<m>
.
1..2
Number of the software CDR setup
Parameters:
<SerialStandard>
CUSTOM | USB20 | USB31GEN1 | USB31GEN2 |
DISPPORT1
1 | DISPPORT12 | FIBCHAN1 | FIBCHAN2 |
FIBCHAN4 | FIBCHAN8 | FIBCHAN16 | HDMI12 | HDMI14 |
HDMI20 | PCIGEN1 | PCIGEN2 | PCIGEN3 | PCIGEN4 |
SATAGEN1500 | SATAGEN11667 | SATAGEN1 |
SATAGEN2500 | SATAGEN21667 | SATAGEN2 |
SATAGEN3500 | SATAGEN31667 | SATAGEN3 | SASGEN1 |
SASGEN2 | SASGEN3 | TB10G | XAUI | CUSTOM | USB20 |
USB31GEN1 | DISPPORT11 | DISPPORT12 | FIBCHAN1 |
FIBCHAN2 | FIBCHAN4 | HDMI12 | HDMI14 | HDMI20 |
PCIGEN1 | PCIGEN2 | SATAGEN1500 | SATAGEN11667 |
SATAGEN1 | SATAGEN2500 | SATAGEN21667 | SATAGEN2 |
SATAGEN3500 | SATAGEN31667 | SATAGEN3 | SASGEN1 |
SASGEN2 | XAUI
*RST: CUSTOM
Usage: Asynchronous command
CDR:SOFTware<m>:ESBRate:SOURce <BitrateSource>
Selects the source of the data stream, which is analized to recover the clock.
Suffix:
<m>
.
1..2
Number of the software CDR setup
Parameters:
<BitrateSource> C1W1 | C2W1 | C3W1 | C4W1 | R1 | R2 | R3 | R4
Usage: Asynchronous command
CDR:SOFTware<m>:ESBRate:BREStimate
Estimates the bit rate once, for the current acquisition.
Suffix:
<m>
.
1..2
Number of the software CDR setup
Usage: Event
Asynchronous command
CDR:SOFTware<m>:ESBRate:CONTinuous <BitrateEstimation>
Enables ongoing correction of the bit rate.
Jitter analysis and clock data recovery