R&S RTO6 - Page 2537

Remote control commands
R&S
®
RTO6
2537User Manual 1801.6687.02 ─ 05
POWer:SLEWrate:RESult:PPEak?.................................................................................
2538
POW
er:SLEWrate:RESult:RMS?................................................................................... 2538
POWer:SLEWrate:RESult:STDDev?.............................................................................. 2539
POWer:SLEWrate:RESult:WFMCount?.......................................................................... 2539
POWer:SLEWrate:SOURce <Source>
Selects the source for the slew rate measurement.
Parameters:
<Source> CURRENT | VOLTAGE
*RST: VOLTAGE
POWer:SLEWrate:AUTO <Autoscale>
Selects the scaling for the display of the results.
Parameters:
<Autoscale> AUTO | MANUAL
*RST: MANUAL
POWer:SLEWrate:AVGDeriv <A
vgDerivative>
Activates or deactivates average.
Parameters:
<A
vgDerivative> ON | OFF
*RST: ON
POWer:SLEWrate:EXECute
Starts the slew rate measurement.
Usage: Event
ACQuire:ARESet:MODE <ArtmRst>
Defines when the envelope and average evaluation restarts.
Parameters:
<ArtmRst> NONE | TIME | WFMS
TIME
Restarts the envelope and average calculation after the time
defined with ACQuire:ARESet:TIME.
WFMS
Restarts the envelope and average calculation after a number of
acquired waveforms defined with ACQuire:
ARESet:COUNt
on page 1335.
*RST: NONE
Power analysis (option R&S RT
O6-K31)