R&S RTO6 - Page 339

Measurements
R&S
®
RTO6
339User Manual 1801.6687.02 ─ 05
If "Peak excursion" is 30 dB, the peaks 1 to 5 are found. If "Peak excursion"
is 20
dB,
also the peaks 6 to 10 are found. The cursor position is on peak 6.
Remote command:
CURSor<m>:PEXCursion on page 1630
MEASurement<m>:SPECtrum:PEXCursion on page 1514
Max results
Sets the maximum number of measurement results that are listed in the result table.
Available for peak list and harmonic search measurements.
Remote command:
MEASurement<m>:SPECtrum:RESult<n>:COUNt on page 1514
Result mode
Selects the the way the measurement results are displayed. Available for peak list and
harmonic search measurements.
"Absolute"
The harmonics/peaks are shown in absolute value, dBm.
"Relative"
The level of the carrier is shown in absolute value dBm. The values
the harmonics/peaks are shown relatively to the carrier in dBc.
Remote command:
MEASurement<m>:SPECtrum:
RESult<n>:MODE on page 1515
Result labels
For peak lists only, requires option R&S RTO6-K37: Use labels to describe the detec-
ted peaks in the spectrum diagram.
You can configure what is displayed in the labels. To change the label design, use
"Menu" > "Settings" > "Appearance" > "Peak List", see Chapter 4.3.9, "Peak list
appearance settings", on page 87.
"Enable"
Displays a description for each detected peak in the spectrum dia-
gram.
"Max. peak
count"
Defines the maximum number of peaks that are labeled in the dia-
gram. The result table lists all peaks.
"Show Fre-
quency"
Includes the frequency of the detected peak in the diagram labels.
Remote command:
MEASurement<m>:RESult:
SHLabels on page 1516
MEASurement<m>:RESult:LABorder on page 1315
MEASurement<m>:RESult:INVerse on page 1316
MEASurement<m>:RESult:MAXCount on page 1515
MEASurement<m>:RESult:SHFRequency on page 1516
Automatic measurements