R&S RTO6 - Page 400

Mask testing
R&S
®
RTO6
400User Manual 1801.6687.02 ─ 05
MTESt:SEGMent:REGion on page 1588
MTESt:
SEGMent:COUNt?
on page 1587
Configure
Opens a dialog to define the selected segment.
Definition of segment
The number of the selected segment is shown above the table. In the definition table,
the individual points of the selected mask segment are listed with exact horizontal and
vertical numerical coordinates. Here you can:
●
Insert a new point before the selected point.
●
Append a new point at the end of the list.
●
Remove the selected point from the list.
●
Change the x- and y-values of each point. T
o scale or move the complete segment,
use of
fset and factor values, see Rescale.
Remote command:
MTESt:SEGMent:POINt:ADD on page 1589
MTESt:SEGMent:POINt:REMove on page 1589
MTESt:SEGMent:POINt:INSert on page 1589
MTESt:SEGMent:POINt:X on page 1590
MTESt:SEGMent:POINt:Y on page 1590
MTESt:SEGMent:POINt:COUNt? on page 1589
Mask test settings