Protocol analysis
R&S
®
RTO6
965User Manual 1801.6687.02 ─ 05
See also: Chapter 13.1.1, "Setup - general settings", on page 485
V
ariant
Selects the DDR standard.
"DDR3"
Requires option R&S RT
O6-K91.
Remote command:
BUS<m>:
DDR:STANdard
on page 2387
DQ
Sets the channel for the data output signal.
You can select analog channels "C1" to "C4", and also active math and reference
waveforms as source.
Remote command:
BUS<m>:DDR:DATA:SOURce on page 2388
DQS
Sets the channel for the data strobe signal.
You can select analog channels "C1" to "C4", and also active math and reference
waveforms as source.
Remote command:
BUS<m>:DDR:STRBe:SOURce on page 2388
DDR (option R&S R
TO6-K91 )
To Next Page
Loading...
