R&S RTO6 - Page 1194

Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1194User Manual 1801.6687.02 ─ 05
"Both"
Selects the rising as well as the falling edge.
Remote command:
POWer:
TRANsient:
TRGSlope on page 2557
Level ← Edge trigger
Sets the voltage or current level for the trigger event.
Remote command:
POWer:TRANsient:TRGLevel on page 2557
Output tube tolerance
Specifies a tolerated error band for the signal level.
Remote command:
POWer:TRANsient:HYSTeresis on page 2555
High
Sets the expected signal high-voltage value.
Remote command:
POWer:TRANsient:SIGHigh on page 2556
Low
Sets the expected signal low voltage value.
Remote command:
POWer:TRANsient:SIGLow on page 2556
Optimize scaling
Selects the scaling for the display of the results.
"Autoscale the signals"
Automatically selects the most appropriate scale for the display of the
results.
"Keep present settings"
The present display settings are not changed.
Remote command:
POWer:
TRANsient:
AUToscale on page 2555
Report comment
In this field you can write a comment that is displayed in the measurement report, for
example, a measurement description.
Execute
Starts the "Transient Response" measurement.
Remote command:
POWer:TRANsient:EXECute on page 2555
Output