R&S RTO6 - Page 1868

Remote control commands
R&S
®
RTO6
1868User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<PresetSingleEnd> MV150 | MV200 | MV250 | MV300 | MANual
MV150 | MV200 | MV250 | MV300
2.5 ± 0.15 V; 2.5 ±
0.2 V; 2.5 ± 0.25 V; 2.5 ± 0.3 V, respectively
MANual
Manual setting of user-defined values with BUS<m>:FLXRay:
THReshold<n> on page 1867.
*RST: MV150
BUS<m>:FLXRay:PRDiff <PresetDiff>
Selects a default threshold voltage if BUS<m>:
FLXRay:SRCType is set to
DIFFerential.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<PresetDiff> MV150 | MV200 | MV250 | MV300 | MANual
MV150 | MV200 | MV250 | MV300
±150 mV,
±200 mV, ±250 mV, ±300 mV respectively
MANual
Manual setting of user-defined values with BUS<m>:FLXRay:
THReshold<n> on page 1867.
*RST: MV150
BUS<m>:FLXRay:PRLogic <PresetLogic>
Selects a default threshold voltage if BUS<m>:FLXRay:
SRCType is set to LOGic.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<PresetLogic> V25 | V165 | V125 | V09 | V0 | MANual
V25 | V165 | V125 | V09 | V0
2.5 V (CMOS 5.0 V); 1.65 V (CMOS 3.5V), 1.25 V (CMOS 2.5V),
0.9 V (CMOS 1.8V), 0 V (ground)
MANual
Manual setting of user-defined values with BUS<m>:FLXRay:
THReshold<n>
on page 1867.
*RST: V25
Protocols