R&S RTO6 - Page 1890

Remote control commands
R&S
®
RTO6
1890User Manual 1801.6687.02 ─ 05
Parameters:
<IdPattern> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page
1286.
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:NUFRame
<SearchName>,<NullFrame>
SEARch:TRIGger:FLXRay:NUFRame?
<SearchName>
Searches for the null frame indicator bit, a frame without usable data.
Parameters:
<NullFrame> ONE | ZERO | DC
Bit value: 1, 0, or X (don't care)
*RST: DC
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:PLPReamble <SearchName>,<PayloadPreamble>
SEARch:TRIGger:FLXRay:PLPReamble
? <SearchName>
Searches for the payload preamble indicator bit that indicates a Network Management
V
ector in the payload segment.
Parameters:
<PayloadPreamble> ONE | ZERO | DC
Bit value: 1, 0, or X (don't care)
*RST: DC
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:PCONdition <SearchName>,<PayloadLengthOp>
SEARch:TRIGger:FLXRay:PCONdition? <SearchName>
Sets the operator for the payload length search setting. You can defined an exact
value, or a range.
Parameters:
<PayloadLengthOp>
OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
The payload length is not relevant for the search condition.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one payload
length to be set with
SEARch:TRIGger:FLXRay:PMIN.
Protocols