Remote control commands
R&S
®
RTO6
1936User Manual 1801.6687.02 ─ 05
Parameters:
<DataIndexMin> Range: 1 to 0
Increment: 1
*RST: 1
TRIGger<m>:CXPI:DEXTension:CONDition <DLCEXTOperator>
Set the condition for the DLC extend value. Y
ou can define an exact value or a value
range.
Suffix:
<m>
.
1..3
Parameters:
<DLCEXTOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | L
THan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:
CXPI:
DEXTension:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:CXPI:DEXTension:MIN and
TRIGger<m>:CXPI:DEXTension:MAX.
*RST: EQUal
TRIGger<m>:CXPI:DEXTension:MAX <DLCEXTMax>
Sets the end value of a DLC extend range if TRIGger<m>:CXPI:
DEXTension:
CONDition is set to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<DLCEXTMax>
TRIGger<m>:CXPI:DEXTension:MIN <DLCEXTMin>
Specifies a data extension bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<DLCEXTMin>
Protocols
To Next Page
Loading...
