R&S RTO6 - Page 1935

Remote control commands
R&S
®
RTO6
1935User Manual 1801.6687.02 ─ 05
TRIGger<m>:CXPI:DATA:DMIN <DataMin>
Specifies a data bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<DataMin>
TRIGger<m>:CXPI:DATA:ICONdition <DataIdxOperator>
Set the condition for the data index value. You can define an exact value or a value
range.
Suffix:
<m>
.
1..3
Parameters:
<DataIdxOperator>
EQUal | LTHan | LETHan | GTHan | GETHan | INRange |
RANGe
EQUal | NEQual | L
THan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with the corresponding TRIGger<m>:
CXPI:DATA:IMIN
command.
INRange = RANGe
In range: Set the minimum and maximum value using
TRIGger<m>:CXPI:DATA:IMIN and TRIGger<m>:CXPI:
DATA:IMAX.
*RST: INRange
TRIGger<m>:CXPI:DATA:IMAX <DataIndexMax>
Sets the end value of a data index range if TRIGger<m>:
CXPI:
DATA:ICONdition
is set to INRange or RANge.
Suffix:
<m>
.
1..3
Parameters:
<DataIndexMax> Range: 1 to 0
Increment: 1
*RST: 0
TRIGger<m>:CXPI:DATA:IMIN <DataIndexMin>
Specifies a data index bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Protocols