R&S RTO6 - Page 1934

Remote control commands
R&S
®
RTO6
1934User Manual 1801.6687.02 ─ 05
TRIGger<m>:CXPI:FID:CONDition................................................................................
1939
TRIGger<m>:
CXPI:FID:MAX.........................................................................................1940
TRIGger<m>:CXPI:FID:MIN..........................................................................................1940
TRIGger<m>:CXPI:NM.................................................................................................1940
TRIGger<m>:CXPI:TYPE..............................................................................................1940
TRIGger<m>:CXPI:CT <CT>
Sets the value of the counter (CT), 2 bits indicating the continuity of the frame.
Suffix:
<m>
.
1..3
Parameters:
<CT>
TRIGger<m>:CXPI:DATA:DCONdition <DataOperator>
Sets the condition for the data pattern. You can define no value, an exact value or a
value range.
Suffix:
<m>
.
1..3
Parameters:
<DataOperator>
OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
Any data pattern is considered
EQUal | NEQual | L
THan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:
CXPI:DATA:
DMIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:CXPI:DATA:DMIN and
TRIGger<m>:CXPI:DATA:DMAX.
*RST: OFF
TRIGger<m>:CXPI:DATA:DMAX <DataMax>
Sets the end value of a data type range if TRIGger<m>:CXPI:DATA:
DCONdition is
set to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<DataMax>
Protocols