R&S RTO6 - Page 1951

Remote control commands
R&S
®
RTO6
1951User Manual 1801.6687.02 ─ 05
Parameters:
<ErrorLength> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:ERRor:PARity <SearchName>,<ErrorParity>
SEARch:TRIGger:CXPI:ERRor:PARity
? <SearchName>
Searches for a parity error, if SEARch:TRIGger:CXPI:TYPE is set to ERRor.
Parameters:
<ErrorParity> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:ERRor:UART <SearchName>,<ErrorUart>
SEARch:TRIGger:CXPI:ERRor:UART? <SearchName>
Searches for an UAR
T error, if SEARch:TRIGger:CXPI:TYPE is set to ERRor.
Parameters:
<ErrorUart> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:FID:CONDition <SearchName>,<FrameIDOperator>
SEARch:TRIGger:CXPI:FID:CONDition? <SearchName>
Set the condition for the frame ID. You can define an exact value or a value range.
Parameters:
<FrameIDOperator>
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:
TRIGger:CXPI:
FID:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:CXPI:FID:MIN and
SEARch:TRIGger:CXPI:FID:MAX.
*RST: EQUal
Protocols