R&S RTO6 - Page 1961

Remote control commands
R&S
®
RTO6
1961User Manual 1801.6687.02 ─ 05
TRIGger<m>:MILStd:STATus:SUBSystem......................................................................
1969
TRIGger<m>:MILStd:
STATus:TERMinal......................................................................... 1969
TRIGger<m>:MILStd:TPSPecifier.................................................................................. 1969
TRIGger<m>:MILStd:TYPE <Type>
Sets the trigger type for MIL-1553 analysis.
Parameters:
<Type> STYPe | WTYPe | DATA | CDST | CMD | STATword | ERR
STYPe
SyncTYPe: triggers on a sync impulse.
WTYPe
WordTYPe: triggers on the selected word type.
DA
TA
Triggers on a data word that can be specified.
CDST
CommanDSTatus word: triggers on a command word or on a
status word that can be specified.
CMD
CoMmanD word: triggers on a command word or on a status
word that can be specified.
STATword
STATus word: triggers on a status word that can be specified.
ERR
ERRor: triggers on any combination of protocol errors.
*RST: STYPe
TRIGger<m>:MILStd:DATA:RCONdition <RT
AOperator>
TRIGger<m>:MILStd:CMD:RCONdition <RTAOperator>
TRIGger<m>:MILStd:CDST:RCONdition <RTAOperator>
Sets the operator to define a remote terminal address:
●
DATA: for data words
●
CMD: for command words
●
CDST: for status words
Parameters:
<RTAOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | L
THan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with
TRIGger<m>:MILStd:CDST:RMIN.
Protocols