R&S RTO6 - Page 1962

Remote control commands
R&S
®
RTO6
1962User Manual 1801.6687.02 ─ 05
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:
MILStd:CDST:
RMIN and
TRIGger<m>:MILStd:CDST:RMAX.
*RST: EQUal
TRIGger<m>:MILStd:DATA:RMIN <RT
APatternMin>
TRIGger<m>:MILStd:CMD:RMIN <RTAPatternMin>
TRIGger<m>:MILStd:CDST:RMIN <RTAPatternMin>
Specify a remote terminal address or set the the start value of a remote terminal
address range:
●
DATA: for data words
●
CMD: for command words
●
CDST: for status words
Parameters:
<RTAPatternMin> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page
1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:DATA:RMAX <RTAPatternMax>
TRIGger<m>:MILStd:CMD:RMAX <RTAPatternMax>
TRIGger<m>:MILStd:CDST:RMAX <RTAPatternMax>
Set the end value of a data range if TRIGger<m>:MILStd:CDST:RCONdition is set
to INRange or OORange:
●
DATA: for data words
●
CMD: for command words
●
CDST: for status words
Parameters:
<RTAPatternMax> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page
1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:CMD:CCONdition <WordCntOperator>
Sets the operator to set a specific data word count or mode code pattern.
Parameters:
<W
ordCntOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with
TRIGger<m>:MILStd:CMD:CMIN.
Protocols