R&S RTO6 - Page 1963

Remote control commands
R&S
®
RTO6
1963User Manual 1801.6687.02 ─ 05
INRange | OORange
In range/Out of range: Set the minimum and maximum value of
the range with TRIGger<m>:
MILStd:CMD:
CMIN and
TRIGger<m>:MILStd:CMD:CMAX.
*RST: EQUal
TRIGger<m>:MILStd:CMD:CMAX <WordCntPattMax>
Sets the end value of a data word count/mode code pattern if TRIGger<m>:
MILStd:
CMD:CCONdition is set to INRange or OORange.
Parameters:
<WordCntPattMax> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:CMD:CMIN <WordCntPattMin>
Specifies a data word count/mode code pattern or sets the the start value of a pattern
range.
Parameters:
<W
ordCntPattMin> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:CMD:SCONdition <SubaddrOperator>
Sets the operator to set a specific subaddress/mode pattern.
Parameters:
<SubaddrOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set withTRIGger<m>:MILStd:CMD:SMIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:MILStd:CMD:SMIN and
TRIGger<m>:MILStd:CMD:SMAX.
*RST: EQUal
TRIGger<m>:MILStd:CMD:SMAX <SubaddrPattMax>
Sets the end value of the subaddress range if TRIGger<m>:MILStd:
CMD:
SCONdition is set to INRange or OORange.
Protocols