R&S RTO6 - Page 1964

Remote control commands
R&S
®
RTO6
1964User Manual 1801.6687.02 ─ 05
Parameters:
<SubaddrPattMax> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page
1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:
CMD:SMIN <SubaddrPattMin>
Specifies a subaddress or sets the the start value of a subaddress range.
Parameters:
<SubaddrPattMin> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:CMD:TR <TRFlag>
Triggers on a transmission mode.
Parameters:
<TRFlag> ONE |
ZERO | DC
ONE
Transmit direction.
ZERO
Receive direction.
DC
Either directions.
*RST
: DC
TRIGger<m>:MILStd:CDST:ICONdition <InfoOperator>
Sets the operator to set a specific info for the 9th to 19th bit of a command or status
word.
Parameters:
<InfoOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with
TRIGger<m>:MILStd:CDST:IMIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:MILStd:CDST:IMIN and
TRIGger<m>:MILStd:CDST:IMAX.
*RST: EQUal
Protocols