R&S RTO6 - Page 1967

Remote control commands
R&S
®
RTO6
1967User Manual 1801.6687.02 ─ 05
Parameters:
<ManCodingError> ON | OFF
*RST: ON
TRIGger<m>:MILStd:ERRor:PARity <ParityError>
Triggers on even parity if TRIGger<m>:
MILStd:TYPE is set to ERRor.
Parameters:
<ParityError> ON | OFF
*RST: ON
TRIGger<m>:MILStd:ERRor:SYNC <SyncError>
Triggers on an error of the synchronization if TRIGger<m>:
MILStd:TYPE is set to
ERRor.
Parameters:
<SyncError> ON | OFF
*RST: ON
TRIGger<m>:MILStd:MAXResponse:BITS <MaxResponseTime>
Sets the value for the maximum response time to be triggered on if TRIGger<m>:
MILStd:
TYPE is set to ERRor
Enable the error trigger on maximum response time with TRIGger<m>:MILStd:
MAXResponse:SELect.
Parameters:
<MaxResponseTime> Range: 2E-6 to 262E-6
Increment: 100E-9
*RST: 14E-6
Default unit: s
TRIGger<m>:MILStd:MAXResponse:SELect <MaxRespSel>
Enables the trigger on exceeding the maximum response time if TRIGger<m>:
MILStd:TYPE
is set to ERRor. You can set the maximum time with: TRIGger<m>:
MILStd:MAXResponse:BITS.
Parameters:
<MaxRespSel> ON | OFF
*RST: ON
Protocols