R&S RTO6 - Page 208

Triggers
R&S
®
RTO6
208User Manual 1801.6687.02 ─ 05
Clock source
Selects the input channel of the clock signal.
Remote command:
TRIGger<m>:SETHold:
CSOurce[:VALue] on page 1406
TRIGger<m>:SPATtern:CSOurce[:VALue] on page 1411
Clock edge
Sets the edge of the clock signal to define the time reference point for the setup and
hold time:
"Positive"
Rising edge, a positive voltage change.
"Negative"
Falling edge, a negative voltage change.
"Both"
Both the rising and the falling edge.
Remote command:
TRIGger<m>:SETHold:
CSOurce:EDGE on page 1405
Clock level
Sets the voltage level for the clock signal. Both "Clock level" and "Clock edge" define
the starting point for calculation of the setup and hold time.
Remote command:
TRIGger<m>:SETHold:CSOurce:LEVel on page 1406
Data level
Sets the voltage level for the data signal. At this level, the setup and hold time is mea-
sured.
Remote command:
TRIGger<m>:LEVel<n>[:VALue] on page 1391
Trigger types