R&S RTO6 - Page 2127

Remote control commands
R&S
®
RTO6
2127User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..3
Parameters:
<CRCOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:
TBTO:CRC:MIN
command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:TBTO:CRC:MIN and
TRIGger<m>:TBTO:CRC:MAX .
*RST: EQUal
TRIGger<m>:TBTO:CRC:MAX <CRCPatternMax>
Sets the end value of the frame check range if TRIGger<m>:TBTO:CRC:
CONDition
is set to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<CRCPatternMax> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (do not care).
TRIGger<m>:TBTO:CRC:MIN <CRCPatternMin>
Specifies the frame check bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<CRCPatternMin> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page
1286. The string parameter accepts the bit
value X (do not care).
TRIGger<m>:TBTO:DADDress:CONDition <DestAddrOptor>
Sets the condition for the destination address. You can define an exact value or a value
range.
Protocols