R&S RTO6 - Page 2126

Remote control commands
R&S
®
RTO6
2126User Manual 1801.6687.02 ─ 05
TRIGger<m>:TBTO:ERRor:FEC....................................................................................
2131
TRIGger<m>:TBT
O:ERRor:OOR...................................................................................2131
TRIGger<m>:TBTO:ERRor:ZERO................................................................................. 2131
TRIGger<m>:TBTO:LENGth:CONDition.........................................................................2131
TRIGger<m>:TBTO:LENGth:MAX..................................................................................2132
TRIGger<m>:TBTO:LENGth:MIN...................................................................................2132
TRIGger<m>:TBTO:SADDress:CONDition..................................................................... 2132
TRIGger<m>:TBTO:SADDress:MAX..............................................................................2133
TRIGger<m>:TBTO:SADDress:MIN...............................................................................2133
TRIGger<m>:TBTO:TRGLevel <TriggerLevel>
Sets the trigger level.
Suffix:
<m>
.
1..3
Parameters:
<TriggerLevel> Range: -0.5 to 0.5
Increment: 1E-3
*RST: 0.01
Default unit: V
TRIGger<m>:TBTO:TYPE <Type>
Selects the type of frame to be triggered on.
Suffix:
<m>
.
1..3
Parameters:
<T
ype> STARt | MAC | IDLE | ERRor
STARt
Start of frame.
MAC
MAC frame. This frame contains information that define how to
go about transmitting and receiving frames.
IDLE
IDLE frame. This frame is used for clock synchronization.
ERRor
Error frame. Y
ou can enable the error to be triggered on:
TRIGger<m>:TBTO:ERRor:CRC
TRIGger<m>:TBTO:ERRor:FEC
TRIGger<m>:TBTO:ERRor:OOR
TRIGger<m>:TBTO:ERRor:ZERO
*RST: STARt
TRIGger<m>:TBTO:CRC:CONDition <CRCOperator>
Sets the condition for the frame check. Y
ou can define an exact value or a value range.
Protocols