R&S RTO6 - Page 2130

Remote control commands
R&S
®
RTO6
2130User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..3
Parameters:
<DataIdxOperator> EQUal | LTHan | LETHan | GTHan | GETHan | INRange |
RANGe
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:
TBTO:DATA:
IMIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:TBTO:DATA:IMIN and
TRIGger<m>:TBTO:DATA:IMAX.
*RST: INRange
TRIGger<m>:TBTO:DATA:IMAX <DataIndexMax>
Sets the end value of the index range if TRIGger<m>:TBTO:DATA:ICONdition is
set to INRange or OORange.
Suffix:
<m>
.
1..3
Parameters:
<DataIndexMax> Range: 1 to 0
Increment: 1
*RST: 0
TRIGger<m>:TBTO:DATA:IMIN <DataIndexMin>
Specifies the index bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<DataIndexMin> Range: 1 to 0
Increment: 1
*RST: 1
TRIGger<m>:TBTO:ERRor:CRC <ErrorCRC>
Enables triggering on cyclic redundancy check (CRC) error
.
Suffix:
<m>
.
1..3
Protocols