R&S RTO6 - Page 2307

Remote control commands
R&S
®
RTO6
2307User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:MPHY:DATA:DMAX <SearchName>,<DataMax>
SEARch:TRIGger:MPHY
:DA
TA:DMAX? <SearchName>
Sets the end value of the data range if SEARch:TRIGger:MPHY:DATA:DCONdition
is set to INRange or OORange.
Parameters:
<DataMax> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MPHY:DATA:ICONdition <SearchName>,<DataIdxOperator>
SEARch:TRIGger:MPHY
:DA
TA:ICONdition? <SearchName>
Sets the condition for the index. You can define an exact value or a value range.
Parameters:
<DataIdxOperator> EQUal | LTHan | LETHan | GTHan | GETHan | INRange |
RANGe
EQUal | LTHan | LETHan | GTHan | GETHan
Equal, Less than, Less or equal than, Greater Than, Greater or
equal than. These conditions require one pattern to be set with
the corresponding SEARch:
TRIGger:MPHY:DATA:IMIN com-
mand.
INRange = RANGe
In range: Set the minimum and maximum value using SEARch:
TRIGger:MPHY:DATA:IMIN and SEARch:TRIGger:MPHY:
DATA:IMAX.
*RST: INRange
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MPHY:DATA:IMIN <SearchName>,<DataIndexMin>
SEARch:TRIGger:MPHY:DA
TA:IMIN? <SearchName>
Specifies the index minimum, or sets the start value of a range.
Parameters:
<DataIndexMin> Range: 1 to 0
Increment: 1
*RST: 1
Parameters for setting and query:
<SearchName>
Protocols