R&S RTO6 - Page 2357

Remote control commands
R&S
®
RTO6
2357User Manual 1801.6687.02 ─ 05
EIEOS
Electrical idle exit ordered set
COMP
Compliance pattern
*RST: SKP
TRIGger<m>:PCIE:TLP:ADRT <AddressType>
Sets the address type to be triggered on for the transaction layer type trigger
.
Parameters:
<AddressType> ANY | X32 | X64
*RST: ANY
TRIGger<m>:PCIE:TLP:CFGT <ConfigType>
Sets the configuration type to be triggered on for the transaction layer type trigger
.
Parameters:
<ConfigType> ANY | TYPE0 | TYPE1
*RST: ANY
TRIGger<m>:PCIE:TLP:CPID <TLPCompleterID>
Sets the completer ID to be triggered on for the transaction layer type trigger
.
Parameters:
<TLPCompleterID>
16-bit pattern, see Chapter 24.4.6, "Bit pattern parameter",
on page 1286. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:TLP:CPLS <CplStatus>
Sets the completion status to be triggered on for the transaction layer type trigger.
Parameters:
<CplStatus> ANY | SUCCESS | UNSUPPORTED | RETRY | ABORT
*RST: ANY
TRIGger<m>:PCIE:TLP:DEID <TLPDeviceID>
Sets the device ID to be triggered on for the transaction layer type trigger.
Parameters:
<TLPDeviceID>
16-bit pattern, see Chapter 24.4.6, "Bit pattern parameter",
on page 1286. The string parameter accepts the bit value X
(don't care).
Protocols