R&S RTO6 - Page 2403

Remote control commands
R&S
®
RTO6
2403User Manual 1801.6687.02 ─ 05
EYE<m>:TIMReference:PROTocol:SELect.....................................................................
2407
EYE<m>:TIMReference[:SOURce]
................................................................................ 2407
EYE<m>:MEASurement:MAXPrecision.......................................................................... 2408
EYE<m>[:STATe] <State>
Activates or deactivates the eye diagram.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
EYE<m>:SOURce <MainSource>
Selects the waveform from which the eye diagram is generated (data source). For ana-
log channels, peak detect, envelope, and average waveforms are not supported.
Suffix:
<m>
.
1..4
Parameters:
<MainSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 |
R1 | R2 | R3 |
R4
Usage: Asynchronous command
EYE<m>:HORizontal[:UNIT] <TimeUnits>
Sets the method to define the horizontal scale of the eye diagram.
Suffix:
<m>
.
1..4
Parameters:
<TimeUnits> ATIMe | UINTerval
A
TIMe
Absolute time
UINT
erval
Unit intervals. You can use unit interval, if the nominal frequency
of the clock signal is known.
*RST: UINTerval
Usage: Asynchronous command
EYE<m>:HORizontal:ABSolute:RANGe <HorizontalRange>
Sets the time range that is covered by the eye diagram.
Protocols