R&S RTO6 - Page 631

Protocol analysis
R&S
®
RTO6
631User Manual 1801.6687.02 ─ 05
Select Search Types
Selects one criterion or an AND-combination of criteria to be searched for. If more than
one criterion is selected, all criteria must be fulfilled by a frame for it to be shown in the
search results.
"Start of frame"
Searches for the first rising edge after the transmission start
sequence (TSS).
"Identifier+data"
Searches for the decoded frame content, on header and payload
data:
●
Indicator bits, see
"Indicator bits" on page
631
●
Frame identifier
, see "Frame ID (min/max)" on page 632
●
Payload length, see "Payload length (min/max)" on page 632
●
Cycle count, see "Cycle count (min, max), Step" on page 632
●
Data position, see "Position, Index (min, max) - Data setup"
on page 633
●
Data bit pattern, see "Condition, Data (min, max) - Data setup"
on page 633
"Symbol"
Searches for a symbol or wakeup pattern, see "Symbol
"
on page
633.
"Error condition"
Searches for one or more errors that are detected in the decoded
data, see "Error Condition"
on page 633.
Remote command:
SEARch:TRIGger:FLXRay[:
SSOFrame] on page 1885
SEARch:TRIGger:FLXRay:SSYMbol on page 1885
SEARch:TRIGger:FLXRay:SIDData on page 1885
SEARch:TRIGger:FLXRay:SERRor on page 1884
Indicator bits
Searches for one or more indicator bits at the beginning of the header segment. Each
bit can be set to 0, 1, or X (do not care).
FlexRay (option R&S RT
O6-K520)