R&S RTO6 - Page 877

Protocol analysis
R&S
®
RTO6
877User Manual 1801.6687.02 ─ 05
DP0/DN0 ← Source Connection
Selects the source of the low-power data lanes.
The "DP0" lane has to be present all the time, hence
"Source DP0"
>"None" is not
allowed.
Remote command:
BUS<m>:DPHY:DPZero:SOURce on page 2246
BUS<m>:DPHY:DNZero:SOURce on page 2246
DP1/DP2/DP3 ← Source Connection
Selects the source of the high-speed data lanes.
Remote command:
BUS<m>:DPHY:DPONe:SOURce on page 2246
BUS<m>:DPHY:DPTWo:SOURce on page 2246
BUS<m>:DPHY:DPTHree:SOURce on page 2246
Probe ← Source Connection
Selects the type of probe used for the respective lane. The D-PHY low-power mode
uses a single-ended signal, while the high-speed mode signaling is differential.
Remote command:
BUS<m>:DPHY:CP:PROBe on page 2244
BUS<m>:DPHY:DNZero:PROBe on page 2247
BUS<m>:DPHY:DPZero:PROBe on page 2247
BUS<m>:DPHY:DPONe:PROBe on page 2247
BUS<m>:DPHY:DPTWo:PROBe on page 2247
BUS<m>:DPHY:DPTHree:PROBe on page 2247
Data Rate
Sets a data rate.
Remote command:
BUS<m>:DPHY:DRATe on page 2244
BUS<m>:DPHY:DSPData on page 2245
HS Threshold
Sets the threshold value for the digitization of high-speed data line.
Remote command:
BUS<m>:DPHY:DPZero:HSPeed:THReshold on page 2247
BUS<m>:DPHY:DPONe:HSPeed:THReshold on page 2247
BUS<m>:DPHY:DPTWo:HSPeed:THReshold on page 2247
BUS<m>:DPHY:DPTHree:HSPeed:THReshold on page 2247
Set thresholds
Opens a dialog to set the threshold values.
HS Hysteresis ← Set thresholds
Sets a value for the hysteresis of the respective lane.
D-PHY (option R&S R
T
O6-K580)