R&S RTO6 - Page 945

Protocol analysis
R&S
®
RTO6
945User Manual 1801.6687.02 ─ 05
Remote command:
TRIGger<m>:
PCIE:
TLP:SNOO on page 2358
Requester ID ← TLP (Transaction layer)
Triggers on a requester ID, consisting of the requester's bus number, device number,
and function number.
Remote command:
TRIGger<m>:PCIE:TLP:REID on page 2358
Device ID ← TLP (Transaction layer)
Triggers on a device ID, a field that can be assigned a value by the vendor for classify-
ing root complex register blocks (RCRB). The Device ID is only valid for Configuration
transaction. It is composed of 8-bit us number, 5-bit device number and a 3-bit function
number.
Remote command:
TRIGger<m>:PCIE:TLP:DEID on page 2357
Read/Write ← TLP (Transaction layer)
Triggers on a read and/ or write state.
Remote command:
TRIGger<m>:PCIE:TLP:MERW on page 2358
Address Type ← TLP (Transaction layer)
Triggers on an address type. The address type can be 32 bit or 64 bit.
Remote command:
TRIGger<m>:PCIE:TLP:ADRT on page 2357
Type ← TLP (Transaction layer)
Triggers on a configuration type.
Remote command:
TRIGger<m>:PCIE:TLP:CFGT on page 2357
Routing ← TLP (Transaction layer)
Triggers on a selected message routing type.
Remote command:
TRIGger<m>:PCIE:TLP:MSGR on page 2358
Message Code ← TLP (Transaction layer)
Triggers on a specific message code.
Remote command:
TRIGger<m>:PCIE:TLP:MSGC on page 2358
Status ← TLP (Transaction layer)
Triggers on a completion status.
Remote command:
TRIGger<m>:PCIE:TLP:CPLS on page 2357
PCIe (option R&S R
T
O6-K72)