R&S RTO6 - Page 1086

Jitter analysis and clock data recovery
R&S
®
RTO6
1086User Manual 1801.6687.02 ─ 05
Nominal bit rate
Sets /displays the nominal bit rate. It corresponds to the data rate of the data stream
from which the clock is to be recovered.
Remote command:
ADVJitter<m>:
SIGNal:
BITRate on page 2486
Software CDR Setup
Opens a dialog for configuring the CDR. For details, see Chapter 18.3, "Clock data
recovery", on page 1112.
Explicit clock
Opens a dialog to define the setting of the explicit clock.
Clock frequency ← Explicit clock
Sets the clock freuqnecy of the explicit clock signal. If this value is unknown, you can
use "Estimate clock frequency"
.
Remote command:
ADVJitter<m>:
SIGNal:CLFRequency on page 2488
Estimate clock frequency ← Explicit clock
Calculates an estimate value for the clock frequency.
Remote command:
ADVJitter<m>:SIGNal:CLEStimation on page 2487
Clock multiplier ← Explicit clock
Sets a value for the clock multiplier, the ratio of an internal clock rate to the externally
supplied clock.
Advanced jitter and noise (option R&S R
T
O6- K133/K134)