R&S RTO6 - Page 1512

Remote control commands
R&S
®
RTO6
1512User Manual 1801.6687.02 ─ 05
<MeasType>
parameter value
(remote control)
Measurement
(manual opera-
tion)
Description/Result Suffix
<n>
THDA THD_a Is equivalent to THD. Requires option R&S R
T
O6-
K37.
9
THDU THD_u Requires option R&S RT
O6-K37. 10
THDR THD_r Distortion factor. Requires option R&S R
T
O6-K37. 11
PLISt Peak list List of frequency and peak power value pairs.
Requires option R&S RT
O6-K37.
12
HAR Harmonic search Returns the measured harmonics. For each har-
monic, the frequency and the value are listed. To get
the number of result pairs (= harmonics), use
MEASurement<m>:
RESult:COUNt?.
13
THDF THD_f Root mean square of the sum of all amplitudes of
the harmonic waves in relation to the amplitude at
the fundamental frequency (first harmonic).
Requires option R&S RT
O6-K37.
14
SPAR Arithmetic for spec-
trum measure-
ments
Basic arithmetic calculations with measurement val-
ues and scalars.
15
MEASurement<m>:SPECtrum:CPOWer:BANDwidth....................................................... 1512
MEASurement<m>:SPECtrum:OBANdwidth...................................................................
1513
MEASurement<m>:SPECtrum:CPOWer:CFRequency.....................................................1513
MEASurement<m>:SPECtrum:NDBDown...................................................................... 1513
MEASurement<m>:SPECtrum:PEXCursion....................................................................1514
MEASurement<m>:SPECtrum:ATHReshold................................................................... 1514
MEASurement<m>:SPECtrum:RESult<n>:COUNt...........................................................1514
MEASurement<m>:SPECtrum:RESult<n>:MODE........................................................... 1515
MEASurement<m>:RESult:MAXCount........................................................................... 1515
MEASurement<m>:RESult:SHFRequency......................................................................1516
MEASurement<m>:RESult:SHLabels.............................................................................1516
MEASurement<m>:SPECtrum:LCHeck<n>:VALid........................................................... 1517
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:LIMit................................................. 1517
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:LIMit.................................................. 1517
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:MARGin............................................ 1518
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:MARGin.............................................1518
MEASurement<m>:SPECtrum:CPOWer:BANDwidth <ChPowBw>
Defines the bandwidth over which the channel power is calculated.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Automatic measurements