R&S RTO6 - Page 1887

Remote control commands
R&S
®
RTO6
1887User Manual 1801.6687.02 ─ 05
Parameters:
<CycleCountStep> Range: 1 to 63
Increment: 1
*RST: 1
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:DCONdition <SearchName>,<DataOperator>
SEARch:TRIGger:FLXRay:DCONdition? <SearchName>
Sets the operator to set a specific data pattern or a data pattern range.
Parameters:
<DataOperator> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
The data pattern is not relevant for the search condition.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with
SEARch:TRIGger:FLXRay:DMIN.
INRange | OORange
In range, Out of range: Set the minimum and maximum value of
the range with SEARch:TRIGger:FLXRay:DMIN and SEARch:
TRIGger:FLXRay:DMAX.
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:DMAX <SearchName>,<DataPatternTo>
SEARch:TRIGger:FLXRay:DMAX
? <SearchName>
Sets the the end value of an data range if SEARch:TRIGger:FLXRay:DCONdition
is set to INRange or OORange.
Parameters:
<DataPatternTo> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter", on page 1286. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:FLXRay:DMIN <SearchName>,<DataPattern>
SEARch:TRIGger:FLXRay:DMIN? <SearchName>
Specifies a data pattern, or sets the the start value of a data pattern range.
Protocols