R&S RTO6 - Page 1918

Remote control commands
R&S
®
RTO6
1918User Manual 1801.6687.02 ─ 05
Parameters:
<SerialMessage> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:ERRor <SearchName>,<ErrorCondition>
SEARch:TRIGger:SENT:ERRor
? <SearchName>
Enables the search for specified errors.
Define the error types with SEARch:TRIGger:SENT:PULSeerror, SEARch:
TRIGger:SENT:PPERioderror, SEARch:TRIGger:SENT:FORMerror
on page 1923 and SEARch:TRIGger:SENT:CRCerror.
Parameters:
<ErrorCondition> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:TTYPe <SearchName>,<TSFieldType>
SEARch:TRIGger:SENT
:TTYPe? <SearchName>
Selects the SENT transmission sequence to be searched for.
To enable the search for the transmission sequence, use SEARch:TRIGger:SENT:
TRANsmission.
Parameters:
<TSFieldType> STAT | STDA
STA
T
Searches on the status nibble.
STDA
Searches for the end of the combination of status and data nib-
ble(s).
Define the data conditions with SEARch:TRIGger:SENT:
STATus, SEARch:TRIGger:SENT:TDCN, BUS<m>:SENT:
DNIBbles, SEARch:TRIGger:SENT:TDMN and SEARch:
TRIGger:SENT:TDMX.
*RST: STAT
Parameters for setting and query:
<SearchName>
Protocols