R&S RTO6 - Page 1920

Remote control commands
R&S
®
RTO6
1920User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:SENT:TDMX <SearchName>,<TSDataPatternT
o>
SEARch:TRIGger:SENT
:TDMX? <SearchName>
Sets the end value of an identifier range for SEARch:TRIGger:SENT:DCONdition
INRange or OORange.
Parameters:
<TSDataPatternTo> Numeric or string pattern, Chapter 24.4.6, "Bit pattern parame-
ter", on page 1286. The string parameter accepts the bit value X
(don't care).
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:STYPe <SearchName>,<SMFieldT
ype>
SEARch:TRIGger:SENT
:STYPe? <SearchName>
Selects the serial message sequence to be searched for.
To enable the search for one of the serial message types, use BUS<m>:SENT:
SFORmat and enable with SEARch:TRIGger:SENT:SMSG.
Parameters:
<SMFieldType> ID | IDDT
ID
Searches for the identifier.
T
o set the identifier condition for the serial message, use
SEARch:TRIGger:SENT:SICN, SEARch:TRIGger:SENT:
SIMN and SEARch:TRIGger:SENT:SIMX.
IDDT
Searches for the combination of identifier and data.
To set the identifier condition, use the commands shown above.
To set the data condition, use SEARch:TRIGger:SENT:SDCN,
SEARch:TRIGger:SENT:SDMN and SEARch:TRIGger:SENT:
SDMX.
*RST: ID
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:SENT:SIDType <SearchName>,<SMIDType>
SEARch:TRIGger:SENT
:SIDType? <SearchName>
Sets the message ID format (4 bit or 8 bit) of the enhanced serial message.
Parameters:
<SMIDType> B4 | B8
*RST: B4
Parameters for setting and query:
<SearchName>
Protocols