R&S RTO6 - Page 212

Triggers
R&S
®
RTO6
212User Manual 1801.6687.02 ─ 05
"Logical
operator"
Defines the logic combination of two sources. The sources are chan-
nel 1/2 and channel 3/4 on the first step, and in the second step the
logical combination resulting from the first step.
●
"AND": logical AND, conjunctive combination
●
"NAND": logical NOT AND
●
"OR": logical OR, disjunctive combination
●
"NOR": logical NOT OR
Remote command:
TRIGger<m>:
QUALify<n>:A:LOGic on page 1419
TRIGger<m>:QUALify<n>:A[:ENABle] on page 1418
TRIGger<m>:QUALify<n>:AB:LOGic on page 1420
TRIGger<m>:QUALify<n>:ABCD:LOGic on page 1420
TRIGger<m>:QUALify<n>:B:LOGic on page 1419
TRIGger<m>:QUALify<n>:B[:ENABle] on page 1418
TRIGger<m>:QUALify<n>:C:LOGic on page 1419
TRIGger<m>:QUALify<n>:C[:ENABle] on page 1418
TRIGger<m>:QUALify<n>:CD:LOGic on page 1420
TRIGger<m>:QUALify<n>:D:LOGic on page 1419
TRIGger<m>:QUALify<n>:D[:ENABle] on page 1418
Trigger Levels
Define the trigger level for each input channel. For state and pattern trigger, the trigger
level is a decision threshold: If the signal value is higher than the trigger level, the sig-
nal state is high (1 or true for the Boolean logic). Otherwise, the signal state is consid-
ered low (0 or false) if the signal value is below the trigger level.
You can set the trigger levels for all channels to the same value, see "Use data level
for clock level" on page 209.
Additional settings: Timing
"Timing" adds time limitation to the pattern condition.
"Off"
No time limitation. The trigger occurs if the pattern condition is fulfil-
led.
"Timeout"
Defines how long the result of the pattern condition must be true or
false.
"Width"
Defines a time range for keeping up the true result of the pattern con-
dition. The range is defined in the same way as for width and interval
triggers, see "Range
"
on page 199.
Remote command:
TRIGger<m>:PATTern:
MODE on page 1408
TRIGger<m>:PATTern:TIMeout:MODE on page 1409
TRIGger<m>:PATTern:TIMeout[:TIME] on page 1409
TRIGger<m>:PATTern:WIDTh:DELTa on page 1410
TRIGger<m>:PATTern:WIDTh:RANGe on page 1409
TRIGger<m>:PATTern:WIDTh[:WIDTh] on page 1410
Trigger types