R&S RTO6 - Page 2158

Remote control commands
R&S
®
RTO6
2158User Manual 1801.6687.02 ─ 05
INRange | OORange
In range, out of range. These conditions require a port number
range to be set using TRIGger<m>:
USB:PMIN
and
TRIGger<m>:USB:PMAX.
*RST: OFF
TRIGger<m>:USB:PMIN <Port>
Specifies the port number, or sets the the start value of a port number range.
Parameters:
<Port>
TRIGger<m>:USB:PMAX <PortT
o>
Sets the the end value of a port number range if TRIGger<m>:
USB:PCONdition is
set to INRange or OORange.
Parameters:
<PortTo>
TRIGger<m>:USB:SCONdition <OperatorSEU>
Sets the operator to set a specific SEU or an SEU range. The SEU values are set with
TRIGger<m>:USB:SMIN and
TRIGger<m>:USB:SMAX.
For SEU, see "SEU" on page 831.
Parameters:
<OperatorSEU> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one SEU value
to be set using
TRIGger<m>:USB:SMIN.
INRange | OORange
In range, out of range. These conditions require a range of SEU
values to be set using TRIGger<m>:USB:SMIN and
TRIGger<m>:USB:SMAX.
*RST: OFF
TRIGger<m>:USB:SMIN <SEU>
Specifies the SEU, or sets the the start value of an SEU range.
Parameters:
<SEU>
Protocols